The BMP280 driver for temperature sensing is used in conjunction with the BMP280 sensor to measure the pressure of the sensor’s surroundings. The BMP280 can also measure pressure with the same sensor.
The BMP280 driver for temperature sensing has two parameters that need to be configured:
This is the address the device is being referenced by on the I2C bus. The BMP280 can have an address of 0x76 or 0x77 with a default address of 0x76. The address can be changed to 0x77 by connecting GND to the SDO/ADR pin of the sensor.
The resolution depends on the measurement system of the central core. If set to imperial, the resolution is in F (degrees Fahrenheit) and in metric it is in C (degrees Celsius).
The resolution in metric is ranging from 0 to 5 Celsius with a default value of 1.
The resolution in imperial is ranging from 0 to 9 degrees Fahrenheit with a default value of 1.
For example in in the metric system, if our latest reading was 25C and the resolution is set to 1.5, the builder base is not going to notify the central core unless the value is <23.5 or >26.5.
The SDA and SCL, and GND pins are connected between the Builder Base and the BMP280, as well as the VIN and 5V pins.
Serial Data Line
Serial Clock Line
This pin provides the power
This pin provides the GND
How to write an App
Navigate to the App Builder and create a new application. You can find the “Temperature” code object under the “Hardware” Tab in the object drop down menu on the left, or you can also use the search bar.
Drag the “Temperature” Object onto the canvas.
Next, locate the “Text” Object under the Interface tab and drag it onto the canvas.
Finally, connect the “Temperature” port from the Temperature Object to the “In” port on the Text object and save your application.
How to create a firmware
Navigate to the Firmware Builder and create a new firmware file.
Click the “+ Add Hardware” button which will open a modal window. Scroll down in the list to find the “Sensor” section and select “temperature”
Give your device a name, and click “Add Device”
Next, select the “BMP280” driver under the driver dropdown menu.
For this example we select:
I2C Address: 0x76
You may now save your firmware file and upload it to one of your clients.